The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Rokcrln · 02-28-2006, 07:52 PM

67ChevyRedneck~ Yes we are planning on adjusting the post and will most will be putting in power windows as well. As far as the pinch area on the door what I normally do if it is not showing yet is flood the area with a rust disolver (like rust mort) and then flood it with a por15 type product. #rd step is hope for the best.

Well I went out after lunch and remembered I needed to finish the top rail of the door opening before I finished the door it self. I had some pieces from our donor cab but they were not long enough for the area and the profile was not quite right. So out came the sheet steel and I made the pieces I needed.

Kevin

02-28-2006, 07:52 PM	#106
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Re: Project Penicillin~ 68 crewcab build up! 67ChevyRedneck~ Yes we are planning on adjusting the post and will most will be putting in power windows as well. As far as the pinch area on the door what I normally do if it is not showing yet is flood the area with a rust disolver (like rust mort) and then flood it with a por15 type product. #rd step is hope for the best. Well I went out after lunch and remembered I needed to finish the top rail of the door opening before I finished the door it self. I had some pieces from our donor cab but they were not long enough for the area and the profile was not quite right. So out came the sheet steel and I made the pieces I needed. Kevin Attached Images