The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Baketown Scotty** · 07-07-2006, 05:04 PM

I recently added longer brake lines in the front from frame rails to wheels due to new lift. Have a leak at the junction block on inside of frame rail, drivers side. It's hard to see with motor and all in the way. I'm thinking I either installed or did not install one of those copper washers in the correct place. Any one have an exploded view of this? Service manual does not show it. Does it go: bolt, copper washer, junction block, etc? Or: bolt, junction block, copper washer?

07-07-2006, 05:04 PM	#1
Baketown Scotty Junior Member Join Date: Oct 2005 Location: Bakersfield, CA Posts: 304	Brake Line Junction, 1969 K5 I recently added longer brake lines in the front from frame rails to wheels due to new lift. Have a leak at the junction block on inside of frame rail, drivers side. It's hard to see with motor and all in the way. I'm thinking I either installed or did not install one of those copper washers in the correct place. Any one have an exploded view of this? Service manual does not show it. Does it go: bolt, copper washer, junction block, etc? Or: bolt, junction block, copper washer?