The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

ZZ4Blazer · 08-08-2006, 05:24 PM

You had mentioned that it was narrowed 4", does that mean the track width from stock is narrowed 4"? 2" per side then?

It was also mentioned the distributor wont come out. It looks like plenty of clearance IMO. More than my S-10, and I can pull it out still. Did you try pulling the cap and rotor off? That gives a lot more clearance.

Very nice looking peice, been eyeing this thread up for a while. This is on my to do list, but not for a while. Where would we order one, when we eventually had the funds to?

08-08-2006, 05:24 PM	#93
ZZ4Blazer Registered User Join Date: Aug 2004 Location: Akron, OH Posts: 95	Re: Dropmember in a 69 C10 You had mentioned that it was narrowed 4", does that mean the track width from stock is narrowed 4"? 2" per side then? It was also mentioned the distributor wont come out. It looks like plenty of clearance IMO. More than my S-10, and I can pull it out still. Did you try pulling the cap and rotor off? That gives a lot more clearance. Very nice looking peice, been eyeing this thread up for a while. This is on my to do list, but not for a while. Where would we order one, when we eventually had the funds to?