The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

70rs/ss · 11-19-2006, 11:13 PM

Good stuff, I seal all my intakes with Ultra copper on the ends!! I got a response from speartech on the 6.0 and the LT1, $450 apiece to make my factory harnesses nice and pretty and to be plug and play, and $300 to do the ecm for the 6.0 and $150 for the LT1. They said they'd drop $100 off if I did both, so I'll do them together to save $100. Thanks for the advice and direction shifty!! I was a little in the dark and going several different directions with all this stuff!!

11-19-2006, 11:13 PM	#49
70rs/ss Registered User Join Date: Dec 2004 Location: Northern AZ Posts: 7,271	Re: Lt1 Engine Harness & Swap Good stuff, I seal all my intakes with Ultra copper on the ends!! I got a response from speartech on the 6.0 and the LT1, $450 apiece to make my factory harnesses nice and pretty and to be plug and play, and $300 to do the ecm for the 6.0 and $150 for the LT1. They said they'd drop $100 off if I did both, so I'll do them together to save $100. Thanks for the advice and direction shifty!! I was a little in the dark and going several different directions with all this stuff!!