The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*rage'nrat638* · 03-11-2007, 12:32 AM

#4 THIS IS THE REAR BOWL REMOVED.
here you can see the rear bowl removed, and the secondary metering plate exposed.
HERE AGAIN..
be very carefull not to break off the alignment tabs on this plate.
you can see how the rear bowl gasket was cut/torn at the top from over tighting and caused leaking.

this is where looking at your instructions come's in handy to know if your missing any parts. i will be adding a second plate to this set-up on reinstall.

use your gasket remover !!!!!!!

03-11-2007, 12:32 AM	#4
rage'nrat638 Account Suspended Join Date: Mar 2003 Location: THE FALL GUY CHICAGO IL Posts: 5,883	Re: Holley 600 Rebuild / Overhaul #4 THIS IS THE REAR BOWL REMOVED. here you can see the rear bowl removed, and the secondary metering plate exposed. HERE AGAIN.. be very carefull not to break off the alignment tabs on this plate. you can see how the rear bowl gasket was cut/torn at the top from over tighting and caused leaking. this is where looking at your instructions come's in handy to know if your missing any parts. i will be adding a second plate to this set-up on reinstall. use your gasket remover !!!!!!! Attached Images Last edited by rage'nrat638; 07-25-2007 at 10:16 PM.