Re: Holley 600 Rebuild / Overhaul
#6 LETS START CLEANING
heres my drain pan converted into my cleaning pan...
you can see at the cost of my favorite parts cleaner i am not going to waste it..
i pour a little in the bottom of the pan and move it around with my soft brush.
i clean the day lights out of every part on this thing.
next to me i have a 5 gallon bucket of water, that i did not show. i don't even have to get-up bad back you know. so as i clean each part i wash it off in the water, and blow dry with my compressed air
THE KEY TO ANY CARB JOB
is a clean working area, and compressed air, use you eyes here. blow out every little passage. here in the 2nd to the last picture i point out a little ball check valve made into the plate. how could you clean that out with out compressed air? spray carb cleaner..maybe !!!
hand towel dry all parts and set aside
Last edited by rage'nrat638; 07-25-2007 at 10:24 PM.
|