The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

see ten · 04-01-2007, 08:55 AM

Quite an undertaking you have going there! So, how are you going to make the heat/AC work out? Are you going to use something like one of the custom setups that Vintage Air sells? I noticed you had swapped the panel that the factory heater box bolts to from one side to the other but I didn't know what your intentions were. It would seem that even if the outer box managed to clear the engine you would still be high and dry on the inside. I'm not second guessing your project, I just didn't see this mentioned and was curious what your plans were. Great Job!

04-01-2007, 08:55 AM	#23
see ten WTB this ad Join Date: Sep 2004 Location: Lafayette Georgia Posts: 5,073	Re: 41DegreesSouth Build Thread Quite an undertaking you have going there! So, how are you going to make the heat/AC work out? Are you going to use something like one of the custom setups that Vintage Air sells? I noticed you had swapped the panel that the factory heater box bolts to from one side to the other but I didn't know what your intentions were. It would seem that even if the outer box managed to clear the engine you would still be high and dry on the inside. I'm not second guessing your project, I just didn't see this mentioned and was curious what your plans were. Great Job!