[pgf545]

Solid, I used a cuttoff wheel mounted on a 4" grinder. It went really fast and left a nice finish. I just marked a line and followed it the best I could then cleaned it up with a little air angle grinder. The floor kit came with a tube that mounts under the old and new floors to add support and to weld the floors to. The tube is about 1 1/2 x 3 and comes in 2 pieces with a center connector that you plug weld once you have set the length. The *****in kit that we got was really nice and came with all the pieces you see here. It did take a little time to fit everything the way I wanted it but it came out really nice. If you have anymore questions let me know.

Bernie