The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

1969k10stepside · 06-08-2007, 12:37 PM

Well,the motor is in so I put the headers on and I got out a front drivshaft and set it in place to check clearance.The header on the passenger side is about 1"-2" from the driveshaft.Do you think that's to close? If I had a camera I would take a pic and show how close the driveshaft is to the header but I dont have a camera..I think it seems too close.

06-08-2007, 12:37 PM	#1
1969k10stepside Registered User Join Date: Mar 2006 Location: USA Posts: 21,020	Front driveshaft and header clearance??? Well,the motor is in so I put the headers on and I got out a front drivshaft and set it in place to check clearance.The header on the passenger side is about 1"-2" from the driveshaft.Do you think that's to close? If I had a camera I would take a pic and show how close the driveshaft is to the header but I dont have a camera..I think it seems too close. Last edited by 1969k10stepside; 06-08-2007 at 12:38 PM.