The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Joined the Short Wheelbase Club *69 Tahoe Project*

Frizzle Fry · 07-04-2007, 01:24 AM

You can see in that last pic how close the drive shaft is to the floor

That's with the axle tube basically sitting where the frame used to be (no lower than without a notch).

So... I'll be making a tunnel including modifying the trailing arm crossmember and two rear floor braces

Because of this I've made some wood blocks to prevent it from going any lower than that for now.

07-04-2007, 01:24 AM	#259
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: Joined the Short Wheelbase Club 69 Tahoe Project You can see in that last pic how close the drive shaft is to the floor That's with the axle tube basically sitting where the frame used to be (no lower than without a notch). So... I'll be making a tunnel including modifying the trailing arm crossmember and two rear floor braces Because of this I've made some wood blocks to prevent it from going any lower than that for now. Last edited by Frizzle Fry; 07-04-2007 at 01:42 AM.