****AS OF 4-22-09 - I HAVE MADE 25 MORE SETS AND THEY ARE READY.****
GO TO http://67-72chevytrucks.com/vboard/s...01#post3273001 FOR MORE INFO
I've been putting ya'll off long enough now, but staying busy is a good thing! I got some time today to work on the new design, and things look VERY promising!
Pics are below. Now, these are just test pieces. These are cut from 1/8", as that is what was on the table at the time. The final parts will either be 3/16" or 1/4".
They will consist of two pieces. Also, overlook the washers that I'm using as spacers!!!! I did not have the right length for the two that hold the caliper on, and the ones in between the two brackets will be replaced with a spacer piece that will be welding in place.
I have not finalized a price yet. They will be more than the Impala/Caprice brackets since there is twice the material and a little more labor in them, but they won't be crazy expensive. The final material thickness will also play into the price. Also, my compressor has a hard time keeping up with continuos cutting for the number I will be doing. So the first batch will probably be outsourced to my steel supplier and be laser cut. I will not be upcharging for this, and I will sell them at the same price as if I were cutting them here.
Here are the pics, and I will keep everyone updated. If you have already expressed interest to me, I probably have you on my list. I will do a mass P.M. to all those I have on my list in the very near future.