The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - ex-Navy 68 K10 build thread

kyoung · 07-16-2007, 02:33 PM

Progress 7/16/2007

I started cleaning up the frame for priming and painting. Initially I thought about getting the frame sandblasted but decided I wasn't in a hurry and would just clean it myself. I wanted a rotisserie so I could turn the frame for cleaning and painting but didn't have the room to store one while it was not being used. So I decided to make one out of engine stands.

I already had one engine stand and bought a second one for less than $40 at Harbor Freight. Then with a couple pieces of angle iron I was in business.

07-16-2007, 02:33 PM	#53
kyoung Registered User Join Date: Dec 2006 Location: Alabama Posts: 66	Re: ex-Navy 68 K10 build thread Progress 7/16/2007 I started cleaning up the frame for priming and painting. Initially I thought about getting the frame sandblasted but decided I wasn't in a hurry and would just clean it myself. I wanted a rotisserie so I could turn the frame for cleaning and painting but didn't have the room to store one while it was not being used. So I decided to make one out of engine stands. I already had one engine stand and bought a second one for less than $40 at Harbor Freight. Then with a couple pieces of angle iron I was in business. Attached Images