The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - crossmember swap-drop

jlaird · 12-15-2007, 06:02 PM

I did this. Yes, it is ALOT of work for a little over an inch. If I were to do it over, I would strongly consider a z. If you section the crossmember, don't go more than 1.25. With this amount, you will still need to shave some of the lip of the crossmember so the inner tie rods dont hit it. Good luck with it. If you have any questions, just ask.

12-15-2007, 06:02 PM	#13
jlaird Senior Member Join Date: May 2004 Location: johnstown, NY Posts: 2,393	Re: crossmember swap-drop I did this. Yes, it is ALOT of work for a little over an inch. If I were to do it over, I would strongly consider a z. If you section the crossmember, don't go more than 1.25. With this amount, you will still need to shave some of the lip of the crossmember so the inner tie rods dont hit it. Good luck with it. If you have any questions, just ask.