The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

6T9GMC · 01-11-2008, 07:53 PM

Hello, Im Trying To Weld In My Floor Patch Panels. I Got Them All Fitting Pretty Good And I Drilled Holes In The Panel Where The Floor Supports Are Located, I Tried A Couple Of Tack Welds, But They Didn't Hold. Should I Drill The Hole Through The Supports Also, So The Weld Goes Down In The Hole?

01-11-2008, 07:53 PM	#1
6T9GMC Registered User Join Date: May 2003 Location: MOORE, OK Posts: 146	Help On Welding Patch Panels In. Hello, Im Trying To Weld In My Floor Patch Panels. I Got Them All Fitting Pretty Good And I Drilled Holes In The Panel Where The Floor Supports Are Located, I Tried A Couple Of Tack Welds, But They Didn't Hold. Should I Drill The Hole Through The Supports Also, So The Weld Goes Down In The Hole?