[bigjimzlll]

I used 2x2 square tubing as out riggers. Plan the location for future stuff, liike exhaust. Also plan the rear down bars to hit the frame rails. One tricky part is the roll bar cross brace. If you put it str8 across the seat will be to far forward. Unless you are small statured you will have to bend the cross tube(where the shoulder harness ties too) to conform with the back of the cab. I'll see if I can find a pic. The reason there are 2 tubes on mne is because the bottom tube is too low...it wouldn't of passed tech, it was easier to leave it then remove it.