The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

lyrikz · 05-14-2008, 08:15 PM

So, finished the rocker, floor panel, rear rocker area. So i started moving on to the door... As you can see im doing one side at a time.. Here is what i started off with after sand blasting.

Here is the lower edge of the door.

I then went ahead and cut out all the bad areas. I basically replaced the whole bottom section of the door... I do have some warpage where i welded the door back in place. I have some questions on that after the pics.

to be continueeedd.

05-14-2008, 08:15 PM	#45
lyrikz PITbut Join Date: Sep 2007 Location: monroe washington Posts: 3,041	Re: My build. Project Karma. 71 stepside. So, finished the rocker, floor panel, rear rocker area. So i started moving on to the door... As you can see im doing one side at a time.. Here is what i started off with after sand blasting. Here is the lower edge of the door. I then went ahead and cut out all the bad areas. I basically replaced the whole bottom section of the door... I do have some warpage where i welded the door back in place. I have some questions on that after the pics. to be continueeedd.