|
Re: PROJECT "Father/Son" C-20 Rolling Chassis Build
Rich Thanks for the info. Since I'm located in SoCal - Brothers, CPP, Truck Shop & Classic Industries are all within a 1 hr drive. Will check to see whats available. I picked up my 14 bolt rear disc brake kit (which can be used on the Eaton) on ebay nearly 2 yrs ago. Could not find drums nor eaton conversion kit. But that thanks for the info.
I'm sure others here will be inspired by this build as I have. Too KEWL!
__________________
..............................._________
......___________//___[[___{\ _____
...../__(_(O)_)___/____/____/_(O)_/
1964 C20 Long Stepside 3 Door Crew Cab
- Armbruster-Stageway Conversion
Y2K INDN Chief
"ONE OF A KIND, NOT ONE OF THE CROWD"
Aug 2010 - Front end frame cleanup & engine swap done!!!
June 2011 - Rear end bagged
Sept 2011 - Rebuild motor top end
Sept 2012 - Parked and slowly working on it.
Aug 2013 - Front end bagged - finally!
Aug 2014 - Stepside swap conversion done. Finally ready to start bodywork! Have a few KEWL ideas...
Here is my build thread:
http://www.67-72chevytrucks.com/vboa...d.php?t=335427
Last edited by 64c20crewcab; 09-07-2008 at 01:04 PM.
|