Well almost 10,000 miles since the motor went in and I thought it was time to finish it up. So I made a quick gas filler cover so it can go to Line-X in the morning. I just took some tag board and made the shape I wanted and traced it out on 1018 AKDQ sheet steel. Then after some knee bending and a bit of shrinking on the top and bottom corners to fit just how I wanted it to and it was ready to screw in. I decided not to weld it just in the off chance it ever needs to come off. It should spray in like it was one piece. The Line-X will come up on the rail and stop just before the outer edge (right were the Blue tape is).
I also finally put in a few inner wheel bolts
Kevin
LFD Inc.