The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

6772owner · 11-07-2008, 06:35 PM

First pic of the LT1 being test fit into the truck, its from a 96' Camaro Z28. I must have been
lucky with this because it dropped right in with two us, no problem. I also managed to use the Prothane urethane engine mounts for the 67-72 SBC and they bolted right up to the LT1. The only intereference point so far is the ground connection on the block behind the pass. side engine mount, the nut cant be removed with the engine bolted down... oh well LOL

11-07-2008, 06:35 PM	#7
6772owner Gearhead Join Date: Jan 2008 Location: Colorado Posts: 1,193	Re: Project C10 First pic of the LT1 being test fit into the truck, its from a 96' Camaro Z28. I must have been lucky with this because it dropped right in with two us, no problem. I also managed to use the Prothane urethane engine mounts for the 67-72 SBC and they bolted right up to the LT1. The only intereference point so far is the ground connection on the block behind the pass. side engine mount, the nut cant be removed with the engine bolted down... oh well LOL Last edited by 6772owner; 01-09-2009 at 11:57 PM.