|
Re: welding heater control
It's called "pot metal".I really don't know if you can TIG it.I doubt it but it never hurts to try.If it doesn't work they make a kit to repair the broken levers.It's made of steel.They only take a couple hours to install and from what I can tell they will never break again.In order to make sure you have a good repair remove the cables and clean/lube them so they operate smoothly.I cleaned mine in a parts washer and then laid them in my oil drain pan where I had left oil.It's been 6-7 years and they still work well.I do spray some graphite lube in the ends of the cables regularly.
BTW Any vendor should carry the kit.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion.
You can't fix stupid,not even with duct tape.
"My appearance is due to the fact that "GOD" does punish you for having too much fun!"
Barrett-Jackson has perfected alchemy,they make rust into gold!
"You can lead a horse to water but you can't saddle a duck"
"Cleverly disguised as a 'Responsible Adult'
"Sometimes your Knight in shining armor is just a retard in tinfoil"
Last edited by PanelDeland; 01-04-2009 at 06:35 PM.
|