Quote:
Originally Posted by texastrendz
i was kinda asking the question at the same time, the crossmember in my lwb hangs below the frame rails, does yours not, hope i did not waste my money on the crossmember, for one i have to figure out the carrier bearing and two thats alot of rivets, maybe someone else will jump in and help us both out with our questions, any help would be great thanks
|
if i'm understanding your question, you don't need a new cross member unless you're lookin to lay frame, or close to that.
My setup is bagged, bolt in C notched, with 2.5" blocks. I did cut holes in the x member for exhaust, and i flipped the carrier bearing so it's up higher. depending on your front end setup, your front cross member is going to hit long before the carrier bearing x member.
as for the T arms, i didn't see any need to move them. They are still in the factory location in my setup.
not the best shot, but this shows what i mean by flipping the carrier bearing mount:
there are some other shots showing the mount on page 2 of my build thread
does this help?