Re: Lurker OrrieG Progress Pics
Money saver #2: Master cylinder door.
These are $45 at most of the reproduction places, my cost was $3 (piano hinge would have been $6 but I had a piece). Tricks are rounded corners for hole (squares cut set up stress points to crack) and thumb screw with capture fitting. I will finish the hole with a piece of split vaccum hose to act as a gasket. Also a picture of my trans cover, square hole is old trans shifter location.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread
1964 Chevelle Malibu w/ 355-350TH (daily driver)
Helpful AD and TF Manual Site Old Car Manual Project
|