Nice work!
Ya I have some more, I will try to dig them up. I wish I could have cut the floor out of this car like you did. The owner wanted the rear floor untouched. I had to notch and narrow the frame a bit to make it fit and make the car lay out. I tucked the pinion up as high as I could within reason, to get a good camber angle at ride height. I like where it's set at, but the pumpkin is still too close to the ground to get the exhaust underneath it. I was hoping to do full exhaust on this car, but there really isn't any way to do it without it looking bad, and running oval tube.
I wanted to post a picture of this too. Heres the new MIG welder. I now have a matching set and I love it. Was getting tired of the duty cycle on my Miller, and having a red and blue fleet. This thing welds beautifully.
