[Rack Man]

No real updates lately....I'm kinda stalled....Body has been in "body shop jail" and I'm a little low on funds right now...so It's all good!....However, all the body work is indeed complete and everything is now in urethane primer....

Now I'm trying to figure out the correct sequence to completing the wood bed conversion as far as paint is concerned??..

With the bed being fully dissambled, I'm wondering now, when should I do the actual assembly....after painting the loose bed panels ?.....or partial asssembly of the bed with rear cross sill and front panel only and then paint?....do I paint the intermediate sills loose ?....Or should I fully assemble everything now and just tape all the wood off ?...or maybe I can have the panels "Jammed" with paint, do the full asssembly and then paint the outside skins after the bed is back on the truck?

I originaly purchased everything except the wood and hardware thinking I could reassemble the entire bed and then simply add the wood later...but I soon realized that you can do that as all of the intermediate cross sills sandwich the wood to the bed....!

If anyone has any advise on this subject I would love to hear it!


Dan