Just finished my shifter rod from the column to the lower linkage. The linkage I started with was from a 72 Camino. After getting the the pivot positioned and the bracket on the frame side connected, I needed to figure out the rod from the column to the lower bracket. The rod that I had from the camino wasn't close enough to work, so I bought a 3' piece of 3/8" cold rolled. I used a piece of welding rod for my template
and had to make it clear the the brake pedal when in was in low gear. Column in Park
Column in Low gear
It shifts smoothly and clears the brake lever by 1/2"! Just need to put my 2 clips up top where I drilled a 1/16" hole on each side of the column to hold the rod in place.