Quote:
Originally Posted by Chuck78
I was planning on getting one of the CPP or REZ brackets, but then I saw yours. I know the CPP kit comes with a steel sleeve to couple the steering shaft back together after shortening it. What do you recommend using? I suppose I could weld it back together, grind flush, and then slide a piece of steel pipe over it and weld that on for extra reinforcement. Looking for better solutions than that if there are any.
Thanks Capt.!
|
The way I do it is cut the rag joint flange off of the steering shaft and drill the ramaining shaft out of the center with a 3/4" drill. Then shorten the shaft, slide the flange back over the shaft and weld it to the shaft. This way looks a lot cleaner and is just a better way IMO.