The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**53burb** · 06-12-2009, 08:57 AM

I locked the ring by putting it on then hitting the ring with a hammer & screwdriver until it is locked in. I remember making sure the tab was fully "out" & not depressed when I was done to make sure it was locked in. It fit tight like it should. The ring felt real tight & the pump seemed to fit ok. I will have to check the P/N. It is a Delphi unit that I got from NAPA. I believe the seal was there. I'm pretty sure that it was. I did the pump in my '04 Burb a week before this one & I R & R the pump the same way.

06-12-2009, 08:57 AM	#6
53burb Registered User Join Date: May 2004 Location: Queen Creek, AZ Posts: 1,004	Re: '99 NBS fuel pump I locked the ring by putting it on then hitting the ring with a hammer & screwdriver until it is locked in. I remember making sure the tab was fully "out" & not depressed when I was done to make sure it was locked in. It fit tight like it should. The ring felt real tight & the pump seemed to fit ok. I will have to check the P/N. It is a Delphi unit that I got from NAPA. I believe the seal was there. I'm pretty sure that it was. I did the pump in my '04 Burb a week before this one & I R & R the pump the same way.