The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Thanks for asking.....here is project: Patina'd

prostreetC-10 · 06-18-2009, 12:13 AM

And now onto the bed. All I needed to do was take off exactly one more row on the bed floor. I'm not sure exactly what they are called but I needed to end up on the low part of the bed so I took off one more ridge and stopped on the low part so the fender well would sit flat. Nothing special here. Just a good ole cut-off wheel and goggles. This picture is of the 15.5's not mounted up. I just set them in there to give me an idea of how far I would need to go.

P.S. You'll notice the bed floor has been fully restored!!! lol

06-18-2009, 12:13 AM	#38
prostreetC-10 My Carbon Footprint Join Date: Oct 2008 Location: Orygun Posts: 5,527	Re: Thanks for asking.....here is project: Patina'd And now onto the bed. All I needed to do was take off exactly one more row on the bed floor. I'm not sure exactly what they are called but I needed to end up on the low part of the bed so I took off one more ridge and stopped on the low part so the fender well would sit flat. Nothing special here. Just a good ole cut-off wheel and goggles. This picture is of the 15.5's not mounted up. I just set them in there to give me an idea of how far I would need to go. P.S. You'll notice the bed floor has been fully restored!!! lol Attached Images __________________ A quick "pedalfest" *Still getting loose (carb test)* 496 Initial fire up video! Last edited by prostreetC-10; 06-18-2009 at 12:14 AM.