Quote:
Originally Posted by Tagg33
When you smoothed the firewall how did you deal with the horizontal seam that runs through it? I want my firewall to look just like yours. I'm pulling my engine tomorrow to start smoothing and start my Porterbuilt C4 dropmember install.
|
Thanks!
Well first I used a wire wheel to remove all the factory seam sealer (black sh*t), then I found some rust so I had to cut that out and patch in some pieces and grind the welds down. I also had to use a hammer and dolly to get the seam flat in some areas and tacked it down with a few welds and grind some more. Then fill the seam with all-metal body filler and sand smooth.
Good Luck its a pain in the ass, but its worth it in the end. (
that sounds funny
)