ok 20x10 all the way around
basic mods
front 1/4 spacer and longer studs
rear 1.25 inch spacer (for look only)
machined the center of the front wheel larger(don't really know if that helped)
machied the rotor where the dust cap is (machied down to the race)
turning problems......none
dust cap used......no
if i would have had the rotor machined down and machined thiner, as i seen someone else do no spacer would have been needed
center cap moded..no
spindel type western chassie 2.5
mod the spindal.....no
looked bad ass.....................................................YES
