The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Glock's new project: "Fred" w/ 5.3L LS swap info

menace121978 · 07-31-2009, 10:53 PM

just went out there again... anything IS possible Bob, but the cab mounts arent helping things out much either. can you measure the filter w/ the fittings attached for me? and i can place the measurement on the frame rail to see how far back you would have to go.

take a look at my frame pics and you can see how the sending unit lines point straight across to the hard line that runs to the other side. that might give you a better idea than having to crawl under FRED w/ the cab and bed on.

BTW, the system and new box looks sick!!

07-31-2009, 10:53 PM	#200
menace121978 Registered User Join Date: Jan 2009 Location: orangevale, ca Posts: 3,626	Re: Glock's new project: "Fred" just went out there again... anything IS possible Bob, but the cab mounts arent helping things out much either. can you measure the filter w/ the fittings attached for me? and i can place the measurement on the frame rail to see how far back you would have to go. take a look at my frame pics and you can see how the sending unit lines point straight across to the hard line that runs to the other side. that might give you a better idea than having to crawl under FRED w/ the cab and bed on. BTW, the system and new box looks sick!! __________________ "Dennis the Menace" 1978 Silverado (2wd, 1/2 ton, short bed)complete nut & bolt frame off restomod LQ9/4L80E MY LS SWAP/FRAME OFF BUILD BOOK 2006 TBSS way too much to list Last edited by menace121978; 07-31-2009 at 10:54 PM.