The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

71tahoe · 08-02-2009, 04:31 PM

If the tranny doesn't move and the z-bar bracket on the frame doesn't move and the cab doesn't move, just use the i6 z-bar and screw in the pivot ball to the v8 block. There should be a tapped hole directly across from the frame bracket. If you're running headers you may need to put an offset in the lower part of the z-bar.

08-02-2009, 04:31 PM	#11
71tahoe Registered User Join Date: May 2006 Location: Jonesboro, AR Posts: 916	Re: clutch linkage coming up short...help! If the tranny doesn't move and the z-bar bracket on the frame doesn't move and the cab doesn't move, just use the i6 z-bar and screw in the pivot ball to the v8 block. There should be a tapped hole directly across from the frame bracket. If you're running headers you may need to put an offset in the lower part of the z-bar.