Finished tearing down the engine and got it prepped up for cleaning and painting. The only other thing I will be doing is taking off the intake, replacing the gasket to be safe, and putting temp. bolts in....the PO used some of the nice stainless bowtie bolts and I'm not going to paint over them....
Took the valve covers off for a peak and was pleasantly surprised how clean the heads look. The PO hid a lot but had receipts for the engine and obviously put in new rockers, springs, and pushrods. Heads were cleaned up as well. Looked up the part numbers on MorTec. 333882.....74-80...350/400......76cc chambers
