The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Metal · 10-28-2009, 09:46 AM

Ok here we go...

Maybe some one can make a diagram out of this for you ????

I used 3/4 MDF with Formica on both sides.. It was what was laying around at work back when I still had a job. In fact we used the CNC router and the program is saved. If I had access I could have whipped you up one in about 5 minutes....

Measurements in inches.. All out side dimensions.....

Length 29 wide

High 15, This is up the back as the slant on the front will be longer..

Depth at top 3

Depth at bottom is 7 ..

Now as for the size of the hole I have no idea as of now and really don't want to pull the sub..

Note that the sub is mounted from the outside, also that it is a sealed box packed with poly fill....

Hope this helps....

10-28-2009, 09:46 AM	#11
Metal Registered User Join Date: Mar 2008 Location: tn Posts: 286	Re: box dimensions Ok here we go... Maybe some one can make a diagram out of this for you ???? I used 3/4 MDF with Formica on both sides.. It was what was laying around at work back when I still had a job. In fact we used the CNC router and the program is saved. If I had access I could have whipped you up one in about 5 minutes.... Measurements in inches.. All out side dimensions..... Length 29 wide High 15, This is up the back as the slant on the front will be longer.. Depth at top 3 Depth at bottom is 7 .. Now as for the size of the hole I have no idea as of now and really don't want to pull the sub.. Note that the sub is mounted from the outside, also that it is a sealed box packed with poly fill.... Hope this helps.... __________________ "If at first you don't succeed use more duct tape" Red Green.... Danger --if you meet it promptly and without flinching -- you will reduce the danger by half. Never run away from anything. Never! -Winston Churchill A few of my holsters.............