The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs...

Frizzle Fry · 11-20-2009, 11:16 PM

One of the side projects that's been holding up progress on the Minx is my "Mini Shop." It's about a 10x15 (if that) building that had been left unused for about ten years. After cleaning it out and fixing a broken window I decided to move in

It's a perfect place for the tube bender, air compressor, Blasting cabinet, and powder coating oven.

So I rented a trencher and buried some 3/4" pex and 10ga 3 core wire to run 220 out there. The pex and all the push-lock fitting are awesome for this. Here's what I've done so far. Now back to the car!

(just some bad cell phone pics):

11-20-2009, 11:16 PM	#332
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs... One of the side projects that's been holding up progress on the Minx is my "Mini Shop." It's about a 10x15 (if that) building that had been left unused for about ten years. After cleaning it out and fixing a broken window I decided to move in It's a perfect place for the tube bender, air compressor, Blasting cabinet, and powder coating oven. So I rented a trencher and buried some 3/4" pex and 10ga 3 core wire to run 220 out there. The pex and all the push-lock fitting are awesome for this. Here's what I've done so far. Now back to the car! (just some bad cell phone pics):