The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 67-72 on 88-98 frame?

liftmeup · 01-05-2010, 01:35 PM

You need to make all new mounts and you have to raise the bed floor 4 inches or do a high body lift in the front. kind of a pain. seen it done on a truck in ohio. It could have been done alot better but it will work. Remember these new truck have a Much taller frame than the old ones. these 67-72 are easy to convert to 4x4 on the factory frame just need to swap the perches and crossmembers,trans/case all holes are present. grinder punch hammer, bolts zoom zoom ! I have done 2 takes about 1 day.

01-05-2010, 01:35 PM	#7
liftmeup Registered User Join Date: Jan 2009 Location: Pittsburg PA Posts: 246	Re: 67-72 on 88-98 frame? You need to make all new mounts and you have to raise the bed floor 4 inches or do a high body lift in the front. kind of a pain. seen it done on a truck in ohio. It could have been done alot better but it will work. Remember these new truck have a Much taller frame than the old ones. these 67-72 are easy to convert to 4x4 on the factory frame just need to swap the perches and crossmembers,trans/case all holes are present. grinder punch hammer, bolts zoom zoom ! I have done 2 takes about 1 day. Last edited by liftmeup; 01-05-2010 at 01:36 PM.