Put in some time last night after work on the rear bags and finished plumbing the air lines to the manifold.
Attached a schrader valve to some line and bench tested the rear bags for leaks with soapy water.
Drilled a hole with a hole saw in the upper spring perch and used a cutoff wheel to trim the rest for access to the air line fitting. Mounted the bag and ran the line.
The shocks allow the rear end to drop farther than the bags can extend so I ordered a pair of 18" limiting straps to attach to the shock mounts.
Finished running and securing the lines to the manifold.
Next is to run the electrical, modify the exhaust over the rear end housing, and install the rear height sensors (once the straps come in). Getting closer!