[texasfunk]

Originally Posted by CHEESE

I asked jason and this is waht he said!!

"he finishes out with 500 gritt and water, then tapes it off in the desired size and sprays the base. Then peels tape and sprays the clear."

In order to get to the hole under the tail lamp, they use a long flat brass piece, to reach up inside to the backside of the hole, then weld em up. Be sure to wear a glove when holding the brass piece!

sweet! thanx! helps alot! i have them almost finished up! need to fill the srew holes still, and a little bondo, but i have to work the rest of the week and i wont be able to work on it so i put some primer so it wont rust, but heres some pics!

i also got into a fender bender, luckily i unbolted the bottom bumper bolts to fold it down and sand the bottom of the tails, cause after i got hit from the behind the bumper just folded down! no damage besides the paint on fender, chrome trim is bent, and small dent on fender from side swiping another car, (shoulda seen his! destroyed!!) im glad i drive a good ol piece of american iron!