Quote:
Originally Posted by zammer
Hey thanks Lolife, I wasn't planning on going right down to the frame but... i'm pretty picky about stuff - a bit much sometimes, but i'm glad i ended up there as it turned out good and its nice bolting on stuff to a fresh frame
..
No, i didn't have to cut the end of the spindle down at all.. are some guys needing to do this?
I don't have a build thread but i was thinking of getting one going, I finally figured out how to post pics properly..
|
I'm just trying to clarify this with the 1" specific spindles.
I think the guys with 1.25" specific spindles are required to do this.
Did you grind on the rotor hub at all?