[Phlebmaster]

Progress!!

Honed the cylinders and degreased the block then painted it. I will rent the cam bearing tool and do some research on how to use it. I also did some block modification based on my research to aid the oil return process and oil flow efficiency from the pump.

Here are the obligatory pics......

These are required texts for this project...thanks Paul!


Put a set of junk heads on so I can protect the cylinders



Opened up the oil return holes in the block.


It did not take much to open both sides up.


Here is the rear main cap where the oil pump mounts...I opened the pick-up tube port up and smoothed out the oil path.

Before...


After...