Quote:
Originally Posted by WillieloRidez
Well i have the other crossmember out already and the motor is still in it but i read on a forum that you have to pull the motor. I just took the two lower motor mount bolts out and suported the motor with my cherry picker and the crossmember came right out so im not seeing why you would have to pull it out to put the new crossmember in even after i section it
|
You have a Cool project!
There are a few easier ways to accomplish the 1/2 ton conversion.
Actually you could have left the crossmember in.
Just swap everything from the a-arms out.
I see alot of people "dead set" on pulling the crossmember. It's not necessary.
Another option would have been to swap
just the
lower a-arm and install a 1/2 ton upper balljoint in your upper a-arm.
3rd option would be to use the "conversion" spindles from ECE that will work with your original balljoints and tie rod ends,... and allow you to use 1/2 ton rotors and calipers.
Either way,...
Love your truck. Keep up the good work.