Today I did some more patch panel fitment and then ground the floor down to bare metal and coated it with the
www.nomorerust.com stuff to stop the rust...
I didn't really grind too far into the areas that I will be cutting out so that is why some areas aren't covered...
I will need to see how much I will replace - probably most of the floor area will be going.
I also coated the cab support and kick panel patch pieces with the excess paint that I used on the floor.
If I get time tomorrow - I will see if I can get some of this stuff welded in this weekend. I am still hoping for the 3-17 time line on this side.