[jbjburbs]

from here i will be adding drop spindles and shortening the cups to put the front cross member about 2 inches from the ground. once that is established i will notch and fit rear sheet metal accordingly. i won't be body dropping, but i plan to trim an inch off the body mounts to close the gap between the frame and body (rubber strips will separate the 2). the rockers should be about 3inches from the ground.

The burban won't drag, and i don't believe in reverse rake (ass lower than the front)... oh yea i found some 22's that should look nice..i just need to save up some coin...taxes sucked this year..anyways until we meet again..