[MJN]

So I swapped in a 205 in place of the 203 I had and the 203 had the side torque mount (brackets with two small poly mounts that bolts to the passenger side frame rail) on it. Now with the 205 the large L-shaped bracket that bolts to the transfer case and has the poly mounts through it is too long and does not match up with the holes in the transfer case. I also have the same brackets off a 205 and they are exactly the same as the 203 brackets. Is there any difference in these mounts between a 203 and 205? My GM shop manual shows the two large bolts going through the two poly mounts and the frame with the nuts on the bottom of the frame. The poly mounts rest on the frame rail. But when bolted to my 205 the mounts are above the frame rail, not touching it. Does anyone have a picture of this setup on their 205 to show how it's bolted together?