Re: PO has me PO'd
Had a little problem with clearance on my Cloyes double row timing chain, so I ground down the block some. Also set the sprocket up for 4° advance, to try to build in some low end torque
Also added a .030 wear plate behind the the cam sprocket to add a little protection to the block, misalignment of the sprockets was within specs., so I didn't have to machine cam sprocket
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
Last edited by jaros44sr; 05-14-2010 at 09:11 PM.
|