The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

irish1966 · 06-03-2010, 11:27 AM

I'm getting frustrated with this whole rocker/floor replacement. I'm not sure what I can keep and what I need to replace. I know that the inner rocker is shot, and slightly into the floorpan, but I'm not sure how much of the floor to cut back. I have a new set of floor pans, but I'm irritated, coz I don't know how to go about getting them in. I think I'm slightly over my head with this one. I think I need the lower supports for both front and back pillars. I could patch the holes, but I'm not sure if that's the way to go. Damn mental block!!!

06-03-2010, 11:27 AM	#107
irish1966 Registered User Join Date: Oct 2009 Location: hillsboro, oregon Posts: 484	Re: Irish's 1966 LWB Fleetside I'm getting frustrated with this whole rocker/floor replacement. I'm not sure what I can keep and what I need to replace. I know that the inner rocker is shot, and slightly into the floorpan, but I'm not sure how much of the floor to cut back. I have a new set of floor pans, but I'm irritated, coz I don't know how to go about getting them in. I think I'm slightly over my head with this one. I think I need the lower supports for both front and back pillars. I could patch the holes, but I'm not sure if that's the way to go. Damn mental block!!! Attached Images __________________ Cheers David 66 LWB Fleet (on hold) 64 LWB Fleet (daily driver) 65 SWB Fleet (almost finished as a driver) 64 SWB Fleet (just started - "Tommys Hot Rods" tribute truck) Nothing worth doing, is easy. Last edited by irish1966; 06-03-2010 at 11:29 AM.