Re: Project: Recycle
Quote:
Originally Posted by greg65
I put the sbw glass on bottom and marked it with a sharpie. I come up with 5/16 at the middle.
|
Hhmm.... That was my estimate for it being different (my measurement was w/the side & bottom edges square/even). I guess its closer to what it needs to be than I thought. The plan is to shave about 1.8" off the corner on the pass side; hopefully that does the job.
Thanks again for taking the time to assist w/this!
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 07-04-2010 at 02:50 PM.
|