[SCOTI]

I sanded/DA'd the lense w/some 80 grit & wiped it down w/degreaser. I used some Rustoleum 'Stone Creations' rattle-can texture finish that I picked up @ my local Home Depot. It gives a nice texture (like trunk spray/zolatone); but the texture is a little more aggressive.

I tried the standard 'wrinkle finish' rattle-can stuff but it requires everything to be just right when applying to get the 'best' finish. With this stuff, it's spray & go. I then used VHT's rattle-can epoxy 'satin black' as the top coat (I also sprayed a couple of coats on the back side of the lense).

Overall, I was able to use the original housing parts & saved myself some cash. I can always go w/an aftermarket set-up if desired since this was just some time/effort. I included a close-up shot of the texture & one of the turn indicators.

Next will be sandblasting the outer bezel & a fresh coat of VHT epoxy....