Quote:
Originally Posted by 68 C-10 KID
C20-67_N_MO
Have you looked @ what a warmed over set of Vortech heads flow compared to the heads you bought.
Just asking. A friend and I built a 6" rod 406 sbc solid tappet motor W/ the VT heads for his dads 63 short box and that thing was a bruiser. It would click off high 12.70's every time at the track.
To keep the cost down a little trick you can do is drill the rocker arm studs and bosses and press in roll pins.
Marv I'm so jealous of your heads. Those make my AFR 227s look amateur.
|
No I really haven't.
Got Vortech heads and intake on my truck right now. So with this set I just bought hoping it will perform better than whats on it currently. Also have a flat tappet .488/.510 hyd. cam I am running with a two-plane intake and the same Holley carb that is currently on the vehicle.
Just going to play with this setup before building up a nice 406 setup. I've heard they make some VERY high torque, very close to BBC numbers. So I can't wait to find that out even though it will be a while for that to happen.