Well, spent a few hours on the burb, but didn't get too far. Undoing other people's "customizing" is never fun...
I'm trying to cut the back out, so i can lower the floor and put some better/taller tubs...i've been using a cut-off wheel and it's just taking too long and it isn't very "clean". i'm hoping to bring the truck up to work this week and borrow the industrial tech's plasma cutter to get things removed, so i can start laying it out the rear.
I hope to make the center section removable (bolts w nuts welded to the underside) while the tubs will be welded fast to floor of the truck and seam sealed to the outside body..this is the current rear...